Holosun EPS Torx Screws

Description

We were able to source a Torx screw solution for your Holosun EPS, EPS Carry and SCS Enclose Emitter Optics!  If you’re like us and really dig the new handgun optics that Holosun has been putting out, then you most likely picked up one of the new EPS, EPS Carry or SCS Enclosed Emitter optics.  If you did, then you may have noticed that all of the included screws are too long to allow you to directly mount the optic to the slide of your Sig P365 series handgun.  Like us you most likely had to use the included spacer plate for the screws to have tension and hold the optic down.  Well, we are now providing the needed screws for your optic so that you can have a nice low optic profile.

We also throw in everything you need plus a couple of extras screws.  You’ll receive 4 screws, thread locker and an extended T10 bit so that you can tighten the screws down to 15 inch pounds without scratching the glass or housing of the optic.  Throw the bit in your bag of tools as you’ll end up using it again with other optics/screws!

Included:

• (4) M3-0.5 x 10mm Torx Steel Flat Head Black Oxide Screws (Yes, 2 extra ones, we drop stuff too!)
• (1) Extended T10 Bit (Long Enough to Clear the Top of the Optic and can be used in your FAT Wrench)
• (1) Vibratite Thread Locker (So the Screws Stay Put!)
• *** We recommend tightening screws to 15 inch pounds with a FAT Wrench.